Product description >
Retractable Patio Awning - Shado 4x3m in aluminium and coated polyester
Large width of 4m
Wall fixings supplied,
Coated polyester fabric 280g/m2
Hardware supplied for installation
The Shado awning is a superior quality product, it is solid and will offer you durability. It is ready to be installed on a hardwood support or on a solid concrete or brick wall, thanks to the hardware supplied (wood screws, screws + dowels). The semi-box protects the fabric, once rolled up, from insects, bad weather, dust and sunlight.
With a density of 280g/m2, the polyester fabric will ensure good shading. The fabric is coated with polyurethane to resist UV, weathering and tearing. For extra strength, the seams are doubled in the stressed areas.
Crank handle included for adjusting the projection and folding the awning
The fabric is wound around a robust anodised aluminium tube. It is tensioned with a high-strength aluminium arm, which ensures that the fabric is always taut and easy to open. The fabric is easy to unfold and store. In order to set the desired projection or to fold the awning, simply insert the supplied crank into the eyelet provided and operate it.
Removable, solid awning
For a modern look, the valance has a straight cut and it is removable. The Alombra patio awning is well thought out and can be adjusted to suit your home. The slope can be set with two adjustment screws.
Moreover, it will offer you a good longevity: for an increased robustness, the main parts such as the arms and the roller are made of aluminium. The supports, claws and fixings are made of cast aluminium.
Semi-bloc aluminium structure
Roller (fabric roller): Ø70x1.2mm, in anodised aluminium
Torsion bar: 40x40x1.2mm, reinforced steel
Load bar: 53x43mm, aluminium
Arms: 2 arms, aluminium, 58x29mm and 48x21mm, tensioning system by internal springs and double coated steel cables, ultra resistant.
Canvas: 280g/m2, in polyester coated with polyurethane, UV protection UPF50+ and water repellent.
Shade: 22cm, removable, same material as the fabric.
Doubled seams in the stressed areas
Tilt min/max: 5°/40° (screw adjustment)
Wall bracket: 3, made of cast aluminium
Hardwood fixing: 6 M10x80 screws
Concrete / solid wall mounting: 6 screws and sleeve nuts M14x80mm
Eyelet: crank on the left of the blind (front view)
This product cannot be permanently deployed, in order to avoid the risk of excessive wind load which could damage the product.
It is designed to be installed on a solid wall (brick, concrete), or on hardwood (walls or partitions). If you wish to install the blind in a cavity wall, you will need to use a suitable fastener (chemical, lag bolt)
The fixing kit is not designed for ceiling installation, but for wall installation only.